Failed to format selected partition, Error 0x8004242d

Some Windows 10 users reported that they are unable to format their Hard Drives and the error message says, " Failed to format the selected partition, Mistake 0x8004242d ". You could too encounter 0x80070057 as the accompanying fault code instead. In this commodity, we are going to fix this error with the help of some simple solutions.

Failed to format the selected segmentation, Error 0x8004242d

0x8004242d

There can be many reasons behind this trouble. Such as your OS is incompatible with the mass storage controller or the commuter, issue in information cable or any other hardware, etc. However, nosotros are going to cover every possible solution to this error.

Earlier moving forrad, make sure to check if your SATA Cable is connected perfectly. If it'due south loose tighten it and check if the issue is fixed. If not, keep reading.

These are the things you tin exercise to set up Failed to format the selected partition, Error 0x8004242d.

Utilise DISKPART
Run CHKDSK
Delete all the partitions
Disable UEFI Kicking Support

Let usa talk about them in detail.

1] Use DISKPART

Failed to format selected partition, Error 0x8004242d

The first solution requires you to employDispkpart.exeto make clean the deejay before formatting Hard Drives. So kicking from the Installation Media and open upControl PromptfromAdvanced Options.

Type the following commands and hitting enter

diskpart

list disk

This will bear witness you the list of all the drivers your computer has. You can look at their corresponding sizes to know the one causing the trouble. At present, utilise the following command to select that particular deejay.

sel disk <disk-number>

Note: Replace the <deejay-number> with the number of the disk that you lot are trying to fix.

Run the post-obit command to confirm that yous take selected the correct disk.

det disk

Once, you are sure that the disk you accept selected is right and cleaning it will crusade no harm, run the following command.

clean all

Note: This volition delete all your data. Then, exist enlightened of that.

Finally, use the post-obit command to exit DISKPART.

get out

Hopefully, this volition gear up the mistake for you.

Related: Windows could not format a partition on disk, Fault Code 0x80070057.

2] Run CHKDSK

$Fix Windows\System32\config\SYSTEM is missing or corrupt$

The trouble tin be considering of a bad sector in your hard drive. And then, launchControl Promptsubsequently booting the figurer from Installation Media and run the following command.

                      chkdsk            c: /r

It will ask you to confirm, so, hit "Y" to practice that.

Let the control run and fix the fault.

three] Delete all the partitions

The most common reason for this error is the corrupted Primary Boot Record.The easiest manner to fix this is by deleting all partitions.

Withal, before doing this, brand sure to create a System Fill-in Image.

Related: Nosotros couldn't format the selected partition – Error 0x80070057

4] Disable UEFI Kick Back up

The problem can exist because of a conflict betweenUEFIandBIOS.So, if y'all facing this error try disabling UEFI Boot Support to set up it. You can follow the given steps to do the aforementioned.